3D
Designers
Here
is an approximate 3D model of the motor. You will need to download AutoDesk's viewing software
to Dynamically view the model. You can also download the 3D idrop
block into an ACAD drawing.
Using
Nano Motors with MEGAbitty:
When
the motors are being driven by MEGAbitty using PWM, they can
get rather hot.
There
are some tricks to improve the situation -- such as
sacrificing one bit of PWM resolution to double the drive frequency
helps; adding some series inductance helps (see Yahoo group for example);
and it is possible to swap the Enable and PWM lines in software if
you're careful about what duty cycles you use.
When
stalled the motors drain a lot of power, so take care not to
exceed the specifications defined in the MEGAbitty manual.
Please
read the MEGAbitty Forum messages on ideas on how to use small motors
with the MEGAbitty controller board. There are many good ideas
available..
http://groups.yahoo.com/group/megabitty/
Miniature
Lego Motors
Two geared motors can
be easily connected directly
to LEGO robot wheels, simply using the grooved shaft. designed for a 3mm
diameter rubber belt drive. This produces
are really simple Micro LEGO robot!
