TM
|
|
European based company with global Delivery
________________
________________
________________
If you need support with our products then click here to register > Support Centre
________________
_________________________
________________
News Feeds
You Tube Morphogenesis: Shaping Swarms of Intelligent Robots
______________________
What is Biomimetics? It is the abstraction of good design from Nature.
| Infrared Control Freak Version 1.0 - KIT version
Calibrating the LEDs and Sensors Place the IR-CF about 5cm above a flat table; preferable on a surface that has been covered with back cloth or card. For best results, adjust the IR-LEDs a few degrees more forward and the IR sensors also slightly forward facing. Simple Interfacing of the IR-Control Freak to the Basic Stamp (TM) or other Microcontroller *Basic Stamp is a trade mark of Parallax Inc.
Infrared Control Freak can easily be interface to the Basic Stamp, Atom Microcontroller, BasicX, OOPic, PICAXE, Handyboard and many other Microcontroller systems can. It even has an onboard voltage regulator to allow you to connect a 9v PP3 battery directly. Or it can connect directly to your development board such as the Growbot, Boebot, MKIII, etc.
Interfacing the IR-Control Freak to your PC
Disclaimer :- you connect to your PC or robot controller at your own risk! Please check voltages and current limitations before connection. User Documentation - IR-Control Freak (Notes that these documents are draft versions and currently being update. The functionality has change based on the initial beta testing results. These changes are not reflected in these documents yet.)
|
|
Copyright ROBOTmaker ©
2003. All
rights reserved.
|
